SparkFun PIR Motion Sensor (JST) Proximity Remote- & App-Controlled Vehicle Batteries Any device that uses a

Any device that uses a USB cable for charging or power can be powered with this supply

2x Flex Arms

There is a 2-pin Molex connector with 0

a 5V tolerant I2C interface (with pull-up resistors to 3

SparkFun PIR Motion Sensor (JST) Proximity Remote- & App-Controlled Vehicle Batteries Any device that uses aThis is a simple to use motion sensor. Power it up and wait 1 2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the alarm pin will go low. This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3. 3V. Sensor uses 1. 6mA@3. 3V. The alarm pin is an open collector meaning you will need a pull up resistor on the